How Internal Resistance Affects Battery Terminal Voltage
This article explores the fundamental relationship between a battery's internal resistance and its terminal voltage in real-world circuits. It defines the concepts of electromotive force (EMF) and internal resistance, explains why actual voltage drops when a circuit is active, provides the mathematical formula governing this behavior, and outlines the practical consequences of internal energy loss in power sources.
Ideal vs. Real Batteries
In theoretical physics, an ideal battery is a perfect voltage source. It maintains a constant voltage regardless of how much current is drawn from it. This maximum theoretical voltage is called the Electromotive Force (EMF), denoted as E.
However, real batteries are constructed from physical materials—such as electrolytes and electrodes—that naturally impede the flow of electrons. This inherent opposition to current flow within the power source itself is known as internal resistance, denoted as r. To analyze a real battery in a circuit, physicists model it as an ideal voltage source (E) connected in series with a resistor (r).
What is Terminal Voltage?
Terminal voltage (V) is the actual electrical potential difference measured across the positive and negative terminals of a battery.
- Open Circuit (No Load): When a battery is not connected to a circuit, no current flows. Without current, the internal resistance has no effect. Therefore, the terminal voltage is equal to the EMF (V = E).
- Closed Circuit (Under Load): When a battery is connected to a circuit and powers a device (the load), current (I) flows through the circuit and through the battery itself. As current moves through the battery's internal resistance, a portion of the voltage is lost inside the battery. Consequently, the terminal voltage drops below the EMF (V < E).
The Mathematical Relationship
The effect of internal resistance on terminal voltage is governed by a simple linear equation derived from Ohm’s Law:
V = E - (I × r)
Where:
- V is the terminal voltage (measured in Volts).
- E is the electromotive force or open-circuit voltage (measured in Volts).
- I is the current flowing through the circuit (measured in Amperes).
- r is the internal resistance of the battery (measured in Ohms).
The term (I × r) represents the "internal voltage drop." Looking at this formula, two direct effects become clear:
- Higher Current Reduces Terminal Voltage: If a circuit demands a large amount of current (I increases), the internal voltage drop (I × r) becomes larger, resulting in a lower terminal voltage available to the rest of the circuit.
- Higher Internal Resistance Reduces Terminal Voltage: If the battery has a high internal resistance (r), even a moderate current will cause a significant drop in terminal voltage.
Practical Consequences in Circuits
Understanding internal resistance is critical for explaining several real-world electrical phenomena:
- Heat Generation: The voltage lost inside the battery does not disappear; it is converted into heat. The power dissipated as heat inside the battery is equal to I² × r. This is why batteries become warm or even dangerously hot when discharging at high currents.
- The "Dead" Battery Illusion: As a battery ages or depletes, its chemical composition changes, causing its internal resistance (r) to increase significantly while its EMF (E) stays relatively constant. If you test an old battery with a voltmeter (which draws almost zero current), it might read a healthy 1.5V. However, the moment you put it in a flashlight (applying a load), the high internal resistance causes the terminal voltage to plummet, and the bulb fails to light.
- Application Matching: Different batteries are designed with different internal resistances. A car battery must deliver hundreds of amperes to start an engine, so it is engineered to have an extremely low internal resistance. Conversely, a standard alkaline coin cell has a high internal resistance and is only suitable for low-current devices like wristwatches.